Using my angle finder, I determined the transom-to-sheer corner angle to be 110°, or a 10° outward rake. (The keel-to-transom rake is 12°). Of course, theory is all fine and good... I drew it, I cut it, I planed it. I still had to re-cut it to fit. Cest la vie.
With another angle-finding tool, I determined that the vertical rake from the transom to the midline of the sheer was about 5°. So, I adjusted my planer/jointer to 5° and planed the edge of the knee that will mate to the transom. Happily, it worked great the first time.
A little minimal corner-cleaning with a chisel, and everything fit great. Repeat for the other side.
Ive also heard these pieces referred to as "corner knees." Whatever the proper term is, I still need to finish sanding them.
src="https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEjKZeDDTO3TyEuoGln-_wx0X1I7aCGCNWaZtanDjBWdqE5H9D3bwHavikAkQOwcuiq2MfzChvDRAeTTNOnDm16P7SE2NsxZL3onIT8yWKk6qdFvw-IiJjWBmLz7jN6hOvx7isJk6b72-YEw/s400/IMG_8249.jpg" title="" width="400">Port quarter knee.
 |
| Starboard quarter knee. |
 |
| This is where Im planing to install the rear cleats. |
Minggu, 16 Oktober 2016
0 komentar:
Posting Komentar